Hello @driftLimiter,
Thanks for your reply. I am new to SAP2000 so I am sorry for some of my lack of knowledge. I have already performed a buckling analysis which did not require the use of the yield strength within the material properties. Now, I am trying to determine the stress within the...
@driftLimiter
Thank you for your response. I would like to add the compressive and tensile yield strength for my material (which is a 3D printed material). However, this material doesn't fall under any of the material templates and the "Other" template does not have a spot to add yield strength...
Oops I thought I was in a SAP2000 Forum. This is for SAP2000. Do you know how to add a category so this gets seen by the right people who know about SAP2000.
Hello,
I am trying to create a new material that does not fall under any of the materials in "Material Type." I therefore chose "Other." However, under "Other" material properties there is no spot to put the yield stress of the location. Because I want to do a crushing analysis of the model, the...
