Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by mad4268
-
Inspection/Measurement of Parallelism
I appologize if this post may be confusing or lacking information but I will keep up with it and respond when needed... I have a part with 2 machined surfaces (flats on a diameter, like the flat part of a washer). They are roughly 4" apart. About 3" from the one diameter is an assembled...- mad4268
- Thread
- Replies: 1
- Forum: QC, Inspection & Testing engineering
