Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Macro001

  1. Macro001

    Selection of Structural Members - Thump Rules

    Thank you all
  2. Macro001

    Selection of Structural Members - Thump Rules

    Hi Mr. Mike, Usually I am requested to provide budgetary quotes for steel works. I tried convincing the management several times by pointing out the missing details albeit I am forced to provide the quote in order to maintain the Client - Contractor relation ship. Mostly, Steel works in my...
  3. Macro001

    Selection of Structural Members - Thump Rules

    Good day all, Please help me to sort out the issues listed below Fabrication & Installation of Storage Shed: I would like to understand how we would choose the structural members and their sizes if the requisition shows only the dimension of a shed. For example, requirement is to build a...
  4. Macro001

    Welding of Plates

    Hi Gents, Thanks all of you for the response. Mr. Gerald, I have gone through ESAB and found it useful. I have also tried your old book codes mentioned above but found noway to compile it. The language used, looks unfamiliar to me. Anyway, thanks alot for the support shown. Best Regards,
  5. Macro001

    Welding of Plates

    Hi Gents, Thanks alot for the response. I work in tendering dept. All I need is thumb rule to calculate the man hours required along with welding electrode/filler wire consumption. Lets put it in this way. I will give an example using which you can explain the calculation method. Note: I...
  6. Macro001

    Welding of Plates

    Hi All, I would like to know a few details about welding of plates (for pressure vessel and storage tanks) 01.How long would it take approximately for welding 1 linear meter (Please consider 10 mm thk for plate and skilled welder). How we can apply the factor when thickness increases...
See more

Part and Inventory Search

Back
Top