Hi
you can use Abaqus to mesh the bone
File -----> imports ------> Parts -----> ( chosen igs as the type of file)
after you can mesh with the mesh modulu .
bye
hi
trie to use damping factor (step Manger---> Damping factor--->0.00001) ??with low values.
if not , see the deformation in your model and trying to change the BC
bye
Hi
I work on a model of knee joint consists of two bones (femur tibia)
the tibia made ??a mouvment of rotation relative to femur, after, I need to apply the BC over the local axis system of which rotates with the tibia.
my problem is to define an axis system which rotates with the tibial...
hello carolina000
I think your simulation is an indentation or confined, unconfined compression tissue, Regardless, to solve the problem of contact in these cases, there are two tests
1 - used interference fit to avoid penteration (module interaction -> interaction manger -> for each contact...
hi mengo
1- instale Slier3 3.6 to convert the fibre to mesh supported by abaqus
2- import this mesh by File----> Imports-----> Model (.inp)
i use this idea to imports any structure for analysis with abaqus
