Recent content by m.bagattini

Sure you can, but their performance is lower than the equivalent EN material

OP, you're comparing apples with oranges, as someone else already said. PED doesn't give you directions about how thick a certain part have to be. So it's not correct to compare PED and ASME VIII Division 1: you should compare ASME VIII Division 1 with EN 13445 (that for heat exchangers design...

Thanks @Rob VE for the heads-up

@r6155 are you available, my Master? Thank you @Geoff13 for the feedback, much appreciated

Dear all, calculation of σ5 in formula 4.15.18 (ASME Div. 2 2019) uses Ri for elliptical heads. Ri is defined as "inside radius of the spherical dome or a torispherical head", with no mention of elliptical heads: should I use Di/2 or what? And in the case of torispherical heads, is it Di/2 or...

In last update chart and tabular values for NFC-2 (external pressure charts, Copper–Silicon Alloy) skyrocketed, has anyone noticed this or has an explanation? Thanks in advance, Matteo