Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by LWyatt

  1. LWyatt

    Rubber stamping vs review work of someone that works remotely in another country?

    Hey folks, thanks for giving me a very interesting read! And also for sparking a minor existential crisis! If you would permit a loosely related question..... When I was fresh out of university, I worked for a company providing concrete forms, temporary work platforms, and that kind of thing...
  2. LWyatt

    Dishonest Contractor?

    Thanks Everyone, these replies are super helpful! @Enable I agree, and have a similar philosophy of "professional courtesy". However, I have been "throwing the book" at this contractor for several months now. Each specific instance gets addressed, but the pattern continues..... @MotorCity -...
  3. LWyatt

    Dishonest Contractor?

    The short version: Contractor claims they didn't cut reinforcing bars, but I have before-and-after photos proving that they did. Regardless, the cut bars will be repaired as part of ongoing repair works. Do I need to make an issue out of this? Or is it a moot point since it will all be repaired...
  4. LWyatt

    ETABS "Error in Checking Model"

    Need some guidance when it comes to debugging a model. When I use the "Check Model" feature ("Analyze">"Check Model"), I get a warning that reads "Error in Checking Model". However, the next dialogue box says "Model has been checked. No warning messages were generated. Model" The model also...
See more

Part and Inventory Search

Back
Top