Recent content by Lune

Hello, I requested connector output from history output step module, but when I ran the model I couldn't find the requested parameters (CEF. CU, CUE, CFAILST....) note that my connecters are connected to ground. I appreciate any help on this issue asap. Thanks in advance

Can any one provide help with these warnings: -WHERE TO FIND THE *NORMAL OPTION EVENTHOUGH, I REFINED THE MESH BUT THE WARNING STILL EXISTS?!!!! ***WARNING: Abaqus WILL NOT ADJUST THE SURFACE NORMAL FOR THE SYMMETRY PLANE AT NODE 54 INSTANCE CON OF SURFACE ASSEMBLY_ALLCONSURF...

were you able to find a solution?

Any solution?

What do you mean? if you meant what interaction that causes the problem then it is (int-3/4/5/6) (the interaction of solid faces with middletendon) however, i also tried to create ons set of all surfaces and define one iteraction but nothing was solved. Steps i used to check the normalare as...

File is attached, hope you can help...I desperately need a solution....I searched manuals and internet but seems couldn't find a way... Hope you can revert back with a solution the earliest possible...

were you able to download it?

I uploaded to engineering.com. under name:UPPB020S-ancho-1.cae. dont know another way to do so.

Thnaks for your reply, even smaller mesh did not solve the problem. Am attaching the CAE file to look at, hope u can find a solution.

Can anyone explains what this warning means wARNING: NODE 3 INSTANCE CONC-1 ON SURFACE ASSEMBLY_ALLCONCSURF HAS FACETS WITH NORMAL VECTORS DIFFERING BY MORE THAN 30 DEGREES. CONVERGENCE DIFFICULTIES MAY OCCUR AT THIS NODE WITH FINITE-SLIDING CONTACT. THE NORMAL CONTACT DIRECTION AT THIS NODE...

Am having error:Nodes have incorrect normal definitions. am modeling a truss embedded in a solid (beam) using a conctact pair option interaction. i don;t know how to fix this error.

Am having an error with abaqus: nodes have incorrect definitions! Does anyone have an idea how to solve it?