Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Luis91

  1. Luis91

    Taptite Screws not Fully Seated.

    Material Specification is listed like this: SAE 1022 (Currently used) Neutral Hardened to RC 33-39 There's a coating involved and it's according the PS-11036.
  2. Luis91

    Taptite Screws not Fully Seated.

    Hello guys! (I'm new here!) Basically the post is related to a problem with this type of screws where I have a high ocurrance rate on not getting fully seated when installed (Using an specific torque Target: 24Nm). According to the information I had review, we are suppose to be forming the...
See more

Part and Inventory Search

Back
Top Bottom