Right click, pick options, click on the display tab (upper left) click on the Colors button. Under content pick 2d model space or Sheet/Layout depending on what you’re working in. Under Interface element pick Uniform background and finally under color change to black.
@ ansh93; First welcome to Eng-tips forums, it’s a great place to get information and learn. My advice when asking a question is to added as much detail as possible. To use your original question for example, if you have a specific situation that you need to install a slip-on flange include as...
To expand on my yes answer from earlier. Our inspection procedures call for a dye check on the root & final pass of both of the weld locations. On top of this a 1/8 inch hole is drilled and tapped into what will be the space between welds, prior to installation, so that when all welding is...
This was a topic on another site and some one posted this link for a height adjustable desk system. I’m sure it’s $$$$$
http://www.leuwico.com/web_e/products/office_furniture/cad/work_stations.html
The “cooling tower” in your thread title got me thinking, like the previous responders, of a different type of closed loop cooling system that uses an unpressurized gravity cooling tower.
In theory it should not matter where you put the pump in your pressurized closed loop system.
When it...
My thoughts:
1. Pipe shoe for 600 deg. line along with a good pipe stress engineer to determine the need for guides and anchors.
2. The specs I work with actually require ½” dia. smooth bar stock as the contact point on all supports.
3. The same specs do not allow pipe supports to be fabricated...
"...Consider that, if the piping system fails and someone gets badly hurt, a snarling, blood-sucking attorney may make some real money."
And in this case, rightly so.
One of my questions would be. Is this truly a 60 psig system? If they are this careless with the construction, how much thought put into the process design? Is the system properly protected from over pressure? What is the compressor’s maximum psig output and what happens when this poorly...
I use “The pipe fitter’s and pipe welder’s handbook” by Thomas W. Frankland as a reference and also found the following at Google books. http://books.google.com/books?id=c4QOZm9El4IC&pg=RA1-PA397&dq=45+degree+rolling+offset