Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Loor

  1. Loor

    Crossbonding

    Hi 7anoter4, Is there any other software I can simulate with except vision. Can this be done as well in matlab? I got 33.8V at 500m cable length. Can you check if I'm doing it right? Thanks.
  2. Loor

    Crossbonding

    Hi 7anoter4, Thanks for the documents. But I do have 1 question regarding the calculation according to Prysmian. That one is based on a flat formation. As I want to do mine in trefoil formation, I see that for the induced sheath voltage = Phase A, B & C = IXm Now for the Metallic Shield Loss...
  3. Loor

    Crossbonding

    Hi 7anoter4 (Electrical) Can you send me again the above mentioned pdf article of Mitton Consulting Ltd. single point bonded system curve. I don't get the option to open it. Do you also have the IEEE-575 Appendix D Calculation of Induced Voltages for induced voltage calculation? I would be...
  4. Loor

    Crossbonding

    no the length varie from 3km up to 10km. Using cable of 800sqmm.
  5. Loor

    Crossbonding

    A circuit in trefoil and I would like to know how to do crossbonding on it. Should I apply this on a distance of 500m? Any ideas suggestions on what to focus on?
See more

Part and Inventory Search

Back
Top