I need to use some Microwave arc detectors but only have located sources that include the wave guide or ell assembly mounted to it. All I want is the detector and associated control so that I can mount it on the cavity as required. Can someone advise a vendor or two that deals in un-assembled...
I have a st'd microwave of 2450 MHZ. The problem is that the vendor put a protrusion inside of the short waveguide and it has been refered to as a director. It's about half a ping ball size located between the Magnetron and the microwave cavity. I have to move the Magnetron and it electronics...
You might want to take a serious look at seamless aluminum tube in that size although I think if you check the manufacturing standards, your description would not be acceptable by most vendors. Have you challenged the vendor or other souces if you want to stay with extrusion?
I have seen better...
I have designed an oven to cook with several 2450 MHz microwave Magnetrons and hot air to brown the production of meat on a high temp. conveyor belt. I need to attenuate or snubb the unused microwave from exiting the conveyor in/out port that is about 6" high and 16" wide. How do you...
