Recent content by loka23

Ronald, I have created a sketch in the view for Breakline view boundary. Loka,

Hello, I'm trying to create a break line view boundary using sketch curves. I keep getting a message saying "The selected curve is shorter than the allowed chaining tolerance." Why am I getting this message? Can I change the chaining tolerance? Regard, Loka

Parts is made from bar with conventional machining. Drawing call out is 'Penetrant inspection per ASTM e1417, type 1 fluorescent Dye. I have attached...

Hi, Drawing callout material is 17-4 ph CRES per AMS 5643/H1025. Which non-destructive testing is better to carry like Liquid Penetrant testing per ASTM E 1417 or Magnetic particle testing per AMST E 1444 for this material. Thanks, Loka

Hello, I am a little bit confused about tolerances. Please can anyone help us. Please find the attached picture. 1) how much the Dia 11.20H8 moves vertical(-/+) at worse case when it fastened to Cap. Thanks...

After machining the slot the inside diameter Dia 11.35+/-0,015 should be constrained.

Hello, I have attached the picture of shield. Whether internal diameter 11.35+/-0.015 should be measured in the free or constrained state which unlike Which should be consider a have primary datum and positional tolerance. Cheers...

Thanks for sharing...

What is value of Shear strength of the Material for A286 Alloy (AMS 5731 or 5732)?

What is value of Shear strength of the Material?

Hello, I am calculate the force between base and body in range of 51 to 1412N (12 to 317lbf). Please find the attached hand calculation and share your thoughts. Regards, Lokeshhttp://files.engineering.com/getfile.aspx?folder=e006ba98-433f-42d7-9224-2ee184d5ba20&file=Hand_Calculation.pdf

Manufacturer wants to reduce the top limits to gain greater tolerance and attached ppt.http://files.engineering.com/getfile.aspx?folder=c7a3d28c-4216-4fd6-8d27-3aff5924799e&file=presentation1.pptx

This question from Manufacturer is 'The Bottom Dia 5.31/5.61 C/Bore is tied up to the Dia 6.0/6.3 long bore with 0.050 concentricity symbol. The feature is difficult to measure especially at the machine side. Long bore is also tied to O/D 0.025 concentricity. Requesting to lose some diametrical...

Applicable standards BS8888 for this drawing[highlight #FCE94F][/highlight]

The bottom Dia 5.31/5.61 is tied up to the 6.0/6.3 long bore with a concentricity defined the attached picture. The feature is difficulty to measure especially at the machine side. what tolerance to lose some diametrical limit on the Dia 5.31/5.61 & Dia 6.0/6.3 diameters to gain greater runout...