Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by LKC

  1. LKC

    Use of AWS B2.1 Standard Weld Procedures

    And, thank you again CWIC! I did point to that section (4.1.1.2) in AWS, our customer's point of contention is the use of "The Engineer" in this paragraph and the definition of "Engineer" in section 1.3 is "...duly designated individual who acts for, and in behalf of...
  2. LKC

    Use of AWS B2.1 Standard Weld Procedures

    We recently purchased B2.1-1-019-94 Standard Welding Procedure for CO2 shielded FCAW carbon steel. Our customer contact has told me that I can not use these standard weld procedures to weld to AWS D1.1 because the approval cycle would be a nightmare...he is defining the "engineering...
  3. LKC

    Pre-qualified WPS-use of parameters Table 4.5 AWSD1.1

    Thank you both for the advice and information. I am going to revise my procedures.
  4. LKC

    Pre-qualified WPS-use of parameters Table 4.5 AWSD1.1

    CWIC, Thanks for the input. I was just trying to figure out a way to not have to revise all of the existing weld procedures. Do you have any recommendations on a good resource for writing weld procedures? I am new to the industry and some of these things look like they are making a very...
  5. LKC

    Pre-qualified WPS-use of parameters Table 4.5 AWSD1.1

    I have FCAW procedures that were written in 1996 as pre-qualified weld procedures using AWS D1.1. Our customer is not approving them because he feels that they do not meet the criteria of Table 4.5 as referenced in para 3.6. Specifically he has problems with the ranges we have listed on our...
See more

Part and Inventory Search

Back
Top Bottom