Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by liulh87

  1. liulh87

    femap error message "curve xxx has no facets"

    Thanks Blas I did rebuilt the result shows "ok to delete unreferenced solid geometry? your model constrains invalid geometry that can not be used" I choose ok, then all the surfaces gone. the file has been attached, can you help to take a look. Thanks Lihua...
  2. liulh87

    femap error message "curve xxx has no facets"

    My femap model got error message "curve xxx has no facets", my whole model surface gone, any body can help? Thanks Liulh
  3. liulh87

    update combined load automaticaly in Femap

    Thomash Thanks a lot
  4. liulh87

    update combined load automaticaly in Femap

    Thanks Thomas i do run linear analysis ,Like say i have Load case1 - FX; Load case 2 - Fy; Load case 3 Fz; then i need the conbined load 0.2*Fx+0.3*Fy+0.4*Fz. What i do is go Menu Model/Load/Combine. but i do like this, when i change basic load case data, i need to re-combined them again. you...
  5. liulh87

    update combined load automaticaly in Femap

    Thanks Thomas i do run linear analysis ,Like say i have Load case1 - FX; Load case 2 - Fy; Load case 3 Fz; then i need the conbined load 0.2*Fx+0.3*Fy+0.4*Fz. What i do is go Menu Model/Load/Combine. but i do like this, when i change basic load case data, i need to re-combined them again. you...
  6. liulh87

    update combined load automaticaly in Femap

    How to update the combined load automatically when the basic load case changed in Femap. so that i dont need to re-combined again when the basic load changed.
See more

Part and Inventory Search

Back
Top Bottom