Recent content by liquidsords

We have a John Zinc burner that needs to be replaced in 2 week lead time. Wondering if there are any other vendors that can do this. 45,000,000 btu/hr @10psi delta P sp gr 0.72 95F gas temp approx 4 foot length thanks

I have a 1" OD aluminum tube w/ approx. .08" wall x 12" long, and I would like to insert some sort of well nut or rivet nut at the top of the tube. The tube is counterbored to allow room for the head of the nut. I have no experience with these so I was wondering if anyone could help me out...

Why does the suction need to be larger than discharge?

Thanks for the help. I was able to find some at RAalloys

Thanks I called them. Anyone else? Some more info: Specific gravity is ~0.8, temperature is ~75 F, viscosity ~2.7 Suction pressure is currently at 18 psi, but it is coming through ~1000 equivalent feet of 1" pipe and will therefore drop proportionally with flow. This needs to be validated...

HI I'm looking for 3 feet of 2.5” SCH 40 pipe in any of the following materials with a 1-2 day ARO Haynes HR-160 RA-330 RA-333 INCONEL 617 INCONEL 601 INCONEL 600 If anyone knows a place that stocks these please let me know. I'm calling all over the place. Thanks

Our suction is 1" discharge is 2" Right now our pump is designed for 30 gpm but we only need 2-4. Here's what we need Flow: 2-4 gpm Pressure: - 100 psi differential Product: Jet fuel Suction pressure available: 18 psi Is this something I can buy off the shelf such as a simple ANSI pump? Any...

Thanks for the ideas guys but the hub is cast iron and there is no room for a flange. I'm just going to cap the hub and drill a hole for the drain pipe, then seal the hole with some packing and silicone sealant.

I contacted that website and they said they have a 10" to 4" coupling but the max temp is ambient

I have a 10" drain hub with a 4" sitting approx 2" inside the drain hub. I need to contain the material going into the drain so I was hoping to find a simple pipe coupling to place over the OD of the pipe and drain hub. I found this site but they do not have the size. The product is 250...

Anyone know where I can find a 10" steel pipe cap similar to this? (second from bottom) http://www.mcmaster.com/nav/enter.asp?pagenum=3546 I need to cover a 10" above ground drain (hub) and this seems to be the easiest alternative Thanks

Thanks TD2K. The gauge is for a hazardous waste tank. I am on the Saab website right now. Which features are most important when selecting the right gauge?

anyone have experience with radar level gauges? I am trying to find a good vendor but have never dealt with these before. Thanks

I am trying to inspect a 3/4-10 UNC-2B capnut for use with a 3/4-10 UNC-3A plain stud. The 2B cap nuts will thread on to the 3A studs that I have, but will not even begin to thread on to the 3B gage that I am using to check them. I figure that there must be a reason but I can't explain it...