Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Lilliputien

  1. Lilliputien

    Fitted splined connections

    Hello, I hope to be in the good area . I working on fitted splined connections DIN 5480 - 28 x 1 x 26 x 9H 9g. I have problem with inspection dimensions. The shaft and hub could be control with the dimension over or between measuring circles. I know to define the values M1 and M2 following...
  2. Lilliputien

    Compressor with DMX

    Hi all, I'm always on my problem. I tried to put a compressor gear, but ProE Mecanism stops analysis because I use parts without mass to made connections and to represent the engine gear. I think that it stops itself just because the engine gear is without mass. I just know his position, number...
  3. Lilliputien

    Compressor with DMX

    Yes, but this pages are block on the web co
  4. Lilliputien

    Compressor with DMX

    No simulate, but mede an dynamical analysis... I'm not sure that is the same... But I Try
  5. Lilliputien

    Compressor with DMX

    Hello everybody, I'am afraid because my english is very bad... I'm designer and I wish calculat all part of compresseur. I found how modelise my assembly and my first results are ok. But on my assembly there aren't the gear, I just put the engin on the crankshaft. How modelise the gear and...
See more

Part and Inventory Search

Back
Top Bottom