Well, i was trying to put in words what appears in the drawing, the "in", i meant it to relate the values to the datum A, the "in" doesn't appear in the drawing. Is only milimeters the tolerance.
Trying another time:
" //0.025/ 100 "
it's what appears before the reference to datum A...
Hi everyone
I have a tolerance that states "// 0.025/ 100 in to datum A" in milimeters
I'm interpreting that means parallelism within 0.025 mm over a 100 mm diameter area relative to datum A.
Is it correct?
Tanks
Hi everyone
I have a tolerance that states "// 0.025/ 100 in to datum A" in milimeters
I'm interpreting that means parallelism within 0.025 mm over a 100 mm diameter area relative to datum A.
Is it correct?
Tanks
