I'm looking for new drying system for polymer particles. Those particles are dewatered (moisture content is less than 10%), and are needed to be dried below 1% of moisture. The current system is the fluid bed dryer, which needs lots of heat energy. Would you please give me any idea to reduce my...
I think djak77494's reply is applicable.
There exist factors like heat transfer limitation and heat loss difficult to be determined, the calculation based on your shell side rather than tube side would be much more correct and practical. If your current condensing system is found not to be...
I'm preparing a lab-scale catalytic combustion system. Oxygen, steam, and hydrocarbon are feeded separately into in-line static mixer, and then into the combuster. The tempearture of feed streams is very high, over 600?. The feeds are flammable over a certain concentration of oxygen. If there...
