I have a situation where I need to rerate a heat exchanger to a higher temperature and derate the pressure. The required temperature exceeds the limits of the corresponding exteranl pressure table in Subpart 3. Is it accepatble to interpolate these curves? If not, is there another method for...
I have had previous experience where different states have specific requirements for the type of vavles installed in the blowdown and drain lines of power boilers. Is there any where else in code other than Part PG that discusses specific requirements for valves placed in the blowdown and drain...
I need to design a stainless steel chemical container/storage tank that will be operating at atmsopheric condtions and will be protected from vacuum but it will be configured similar to a vertical pressure vessel with eliptical heads, shell, and support legs welded to the shell. Does API 650...
I have two vessel fabricated per ASME Sec VIII Div 1 and they will be attached by welding nozzles togther. To make up the appropriate distance, I will be placing a small piece of pipe equal in wall thicnesses between the two vessels. The work will be performed by a coded shop. Are there any...
I have a used carbon steel pressure vessel that has no documentation of the type of material that was used to manufacture it. Destructive testing is not an option for identification. In this case, API 510 recommends using SA-283 C when analyzing the pressure retaining capabilities. Also, the...
I have a situation where Boiler Feed Water has amine injected for pH control. Is there an amine concentration vs. temperature relationship where I will need to worry about SCC or general corrosion in carbon steel? Thanks for any advise.
BigInch,
I am trying to analyze the dischage piping of relief valve that discharge into systems that floats on atmosphere (typical flare header with KO pot arrangment). When I speak of analysis, I am needing to perform stress analysis that takes into consideration the impulse forces of a relief...
I am looking for procedure to analyze a closed relief valve system. So far, all I have run across are ways to analyze open relief valve systems. I do have access to Caesar II software. Does anyone know of any specific examples? Thanks.
MiketheEngineer,
I agree with what you have said. The only reason I am asking for codes is it makes it easier to convince the tight pocket clients when I have them to back me up. Thanks for your respones.
Are there any codes or standards that require that backflow preventors are installed to ensure that water used for human consumption is separated from water that can potentionally be contaminated by chemical processes in industial applications. Thanks for any help.
I have a caustic system that will typically operate at 90 deg F with a max of 20% caustic solution. The piping and equipment is constructed of carbon steel and has not been post weld heat treated. I have located several references that specifies that PWHT is only necessary for CS in 20%...
I have an exisitng vessel that will require me to place a nozzle in the same location as an external stiffening ring. My thoughts were to replace the stiffening ring with the same or greater moment of inertia that would have to be removed by "boxing" in the nozzle. Does anyone see a problem...
I have an RO (Reverse Osmosis) skid that will be installed to treat boiler feed water. The water after this treatment skid will be deiozized with a PH of about 5 - 6. What are my piping material options for this service? Is there a threshold for the percentage of deionization were carbon...
