Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by lastoneleftSE
-
Solid Edge ST6 test
thank you for your reply, once you have moved it, I wonder how you can get it back to the same position as it was in a easy way( hard way is putting 3 mate constraints the planes of the part and base coordinate and then deleting them and then put a ground constraint again.)it's not a disaster...- lastoneleftSE
- Post #3
- Forum: Siemens: Solid Edge
-
Solid Edge ST6 test
Hello, Can someone test something for me? in an assembly the first part is basicly grounded(with ground constraint), that basicly means you cant move it because its fully constraint, now with ST7 i can move this so i think there is a problem with ST7 because according to me this shouldn't...- lastoneleftSE
- Thread
- Replies: 3
- Forum: Siemens: Solid Edge
