Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by laserop

  1. laserop

    Amada Lc 3015 XI NT 4kw PART 2

    i see what you mean now, amada have been out and solved the problem and shown us the monitor menu, very handy, I'm not too sure as to when the the optics were last serviced, i shall try find out problem with the 15mm was that i was using europe grade material on japans feeds and speeds, simply...
  2. laserop

    Amada Lc 3015 XI NT 4kw

    Finally some good news, Amada have been out and have done a great job fixing problems, and showing us around the machine, none of the beds were moving, so one fault was the bed not hitting a sensor so basically didn't know where the bed was in correspondence with the chain, the other bed has a...
  3. laserop

    Amada Lc 3015 XI NT 4kw

    Cheers for the tips! machine is being a right bitch, problem after problem so amada are coming out to do some proper training and set the machine up properly. we don't have a polarization filter, where could we get one?
  4. laserop

    Amada Lc 3015 XI NT 4kw PART 2

    im not there at the moment but soon as I'm back at work on thursday i will get some info and pictures, the parts wasn't cutting all the way through and was welded into the sheet, loads of slag underneath. cut some 8mm mild steel with no problem at all, was happy until lunch time came, a nitrogen...
  5. laserop

    Amada Lc 3015 XI NT 4kw PART 2

    sorry to cover this again, does anyone know where i can find or borrow some cut condition data for a Amada Lc 3015 XI NT 4kw? there are several conditions loaded into the machine but ones we do not use a lot, tried cutting 15mm mild steel and had a hard time trying to adjust the settings, had to...
  6. laserop

    Amada Lc 3015 XI NT 4kw

    thats great, good to know there are people are out there with some knowledge with this machine. we was told in the training to change the laser gas every 18 hours using the scale on the maintenance tab/page, however this seems strange as 1 50L bottle of laser gas would last 3 months on our 2.5kw...
  7. laserop

    Amada Lc 3015 XI NT 4kw

    Recently purchases a 2007 Amada lc 3015 XI NT 4kw laser but unfortunately don't have any paperwork or manuals with the machine. is there anywhere or anyone who could help with this? i currently work a 2013 Amada Alpha 4 lc 2415 2.5kw and understand the basics of height test's, lens cleaning...
See more

Part and Inventory Search

Back
Top