Continuing from my last post.
Assuming the headstock of the lathe is 800KG.
In the worst case scenario only two jacking point are touching.
400kg one point
30 MPa concrete
0.57 design compression strength of concrete I got from the internet. (if someone could explain this part to me)...
I require some help for load capacity on a concrete slab.
I currently have a lathe on a 100mm concrete slab
I'm going to assume its 30mPA
It has mesh in the concrete, but I don't know what size.
I'm a machinist by trade so someone with knowledge in civil engineering might be able to point me in...
Hello
I'm replacing two bronze nuts for the raise/lowering screws on a car hoist. The screws also have a safety steel nut above
I will be making them out of a PB1 bronze.
I will attach the link for the material I plan to order
https://www.kormax.com/material/pb1-phosphor-bronze/
They are a...
