Hi,
The views will be aligned automatically when you use template when creating a drawing. In the template you must defined General view and other than Projected
Hi,
you should to create simple text file with command POINT X,Y. Save the file as XXXXXX.SCR. Go to Tools-RunScript, load the file.http://files.engineering.com/getfile.aspx?folder=2518eacb-d74c-4029-ab7e-10abfcd4e907&file=point.jpg
Hi,
Little did I looked at your file. The first two elements are OK. With the third will be difficulties. These two lines does not lie in one plane and thus form a twisted surface. From such an area not likely to be in SW create sheetmetal...
Hi,
This is not a good way to create sheetmetal part from 3D sketch in single step. Proceed stepwise. Create planar sheet, then add cuts, bends, flanges, etc. etc.
Hi,
click on the dimension and insert text (see image)http://files.engineering.com/getfile.aspx?folder=e210429b-9f32-48bd-ac33-9865f6089d47&file=dim.jpg
Hi,
you can use Revolve feature instead of Base extrude. See att image.http://files.engineering.com/getfile.aspx?folder=d082907d-ef38-4228-8259-dea8bafb9332&file=BoltHandle1.jpg