Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by lahori

  1. lahori

    The separation gas system shall be a permissive to start lube oil pumps in order to avoid ingress of

    Hei JJpellin, Please find the attached below.What will happen if you remove this "Permissive to start lube oil pump logic"? Regards Lahorihttps://files.engineering.com/getfile.aspx?folder=59ff088c-aae5-4aa9-852c-959bfd8e33e8&file=attachment.docx
  2. lahori

    The separation gas system shall be a permissive to start lube oil pumps in order to avoid ingress of

    Hi, can somebody please help me here. What does it mean " A permissive to start lube oil pumps ".Actually I am working with seal gas system and this logic is on pressure differential transmitter (PDT) for both at the inlet and out of the compressor barrier gas. Regards YB
  3. lahori

    Seal gas take off from impeller of centrifugal compressor

    Hi, I have a scenario in which seal gas is taken from 3rd impeller of centrifugal compressor. There are no pressure or temperature measurement on this take off. So if I need to find out the seal gas process conditions how should I calculate it. Regards Yasir
  4. lahori

    Balance line in centrifual compresor seal gas system

    Hi Johnny, Thanks for your reply. What is the reason behind to balance both seal chambers to the same the pressure. Regards Yasir
  5. lahori

    Seal gas flow back to the compressor

    Hi, I am working on a Dry Gas Seal Project for Centrifugal compressor. I have a book on Compressor Dry Gas Seal In which following is written "It is also desirable to minimize seal gas consumption. The majority of the injected seal gas flows across the inner labyrinth seal and back into the...
  6. lahori

    Balance line in centrifual compresor seal gas system

    Hello, I am working with Centrifugal compressor gas seal system. Seal are of Dry Gas type. I can see a Balance line on the P&ID of seal system. Can anybody please explain what is the purpose of this balance line? Regards Yasir
  7. lahori

    Hello , Currently I am working wit

    if you do not mind can i have this calculation sheet of yours. i really appreciate your knowledge already. Sharing is Caring.
  8. lahori

    Hello , Currently I am working wit

    if you do not mind can i have this calculation sheet of yours. i really appreciate your knowledge already. Sharing is Caring.
  9. lahori

    Hello , Currently I am working wit

    Hi, Thanks for taking out time to reply. Actually i am working with Dry Gas seals. The arrangement of seals are of tandem type.Over the years Seals are failing because of leakage. So i need to find out the leakage rate through process labyrinth. I have checked the book you suggested but it does...
  10. lahori

    Hello , Currently I am working wit

    Hello , Currently I am working with Centrifugal compressor seal gas system, .It is an existing system and I need to find the leakage rate through the labyrinth. Can somebody please guide me where can I find " Egli, A. 1935. The leakage of steam through labyrinth seals. Transactions of ASME...
See more

Part and Inventory Search

Back
Top