Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by lagfish
-
ball bearing with a flat?
How out-of-round are injection moldings? It needs to seal quite well. I should also mention that these balls will be about 0.10 in diameter.- lagfish
- Post #3
- Forum: Machines & Machining engineering
-
ball bearing with a flat?
Hello, We are looking to use a bearing ball with a flat on it with a depth of less than the radius of the ball. I am wondering if there are already something out there we can use? I can make a few by clamping them in a collet and grinding/machining it down but this would be expensive on a mass...- lagfish
- Thread
- Replies: 4
- Forum: Machines & Machining engineering
-
ball bearing with a flat?
Hello, We are looking to use a bearing ball with a flat on it with a depth of less than the radius of the ball. I am wondering if there are already something out there we can use? I can make a few by clamping them in a collet and grinding/machining it down but this would be expensive on a mass...- lagfish
- Thread
- Replies: 1
- Forum: Bearing design, manufacture and maintenance
