Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by kyphorrhinos
-
Overhung Load (OHL) in Opposing Directions
Seems to easy. The OHL does not return the same values as calculating the force exerted by the belts. Do you think using a FBD with the OHL will produce correct results?- kyphorrhinos
- Post #3
- Forum: Gear and Pulley engineering
-
Overhung Load (OHL) in Opposing Directions
Been reading posts on this site for a while and I finally decided to join so I could ask a question myself. Anyway... My question is regarding Overhung Loads on shafts. Specifically, what happens when there are opposing loads? For example, I have a setup that will drive a pump and a generator...- kyphorrhinos
- Thread
- Replies: 5
- Forum: Gear and Pulley engineering
