Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by KWHP

  1. KWHP

    Help using Loft Command

    Rollupswx, Thank you very much for your help. This was exactly what I needed to presume work.
  2. KWHP

    Help using Loft Command

    Rollupsw, I have attached my ipart of the sketch I am trying to create. From my tutorials, I believe I am suppose to make two sketches offset the distance I want with either a guide rail or centreline. Since this component is "Eccentric" there isn't a true centerline. Any tips would be much...
  3. KWHP

    Help using Loft Command

    I am in need of some help / guidance using the Loft Command. My component I am trying to model is an Eccentric Pipe Reducer. Diameters aren’t critical as long as the fitting can actually be modeled in Inventor. I have tried several times and no such luck. If there is another method other then...
See more

Part and Inventory Search

Back
Top Bottom