Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by kvj

  1. kvj

    Need some help - New job & I'm not producing drawings that are 'good enough'.

    I strongly agree with MadMango about using examples of the checker's approved drawings as a resource of how it should be done to pass muster with him. Check, check, recheck then check again. If the corporate atmosphere there allows, I wouldn't hesitate to bounce a question or two off the...
  2. kvj

    B18.3 length tolerence of fully threaded SHCS

    We do not have a copy of B18.3 and not in the budget to purchase one. We really have had no other need for the spec but for this rare case. If this request is not acceptable on this forum, my apologies. Machinery's Handbook (21st Edition, pg. 1202) doesn’t address manufacturer tolerences. I...
See more

Part and Inventory Search

Back
Top