Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by KVgeo

  1. KVgeo

    Horizontal seismic loads

    @dgillette "When should I use a hammer" = priceless! :) Does anybody else worry about the structure of questions on this board sometimes? @mnoorzay Mccoy answered your question. Horizontal seismic loads are typically applied in the direction of the slide. As such, they tend to decrease...
  2. KVgeo

    Horizontal seismic loads

    Just like everything we do a pseudostatic (or should it be pseudodynamic) analyses are a tool and the key is interpreting the results. Some will tell you that a pseudostatic analysis is a good indicator of potential seismic damage to a structure. A high factor of safety will mean that the...
  3. KVgeo

    Slope Stability Analysis under an Earthquake

    SlopeW will only be able to model the post earthquake stability of the retaining wall. If you know how the earthquake will affect the soil then you can put post earthquake strengths and pore pressures into the model. However, you will have to do a dynamic analysis to fully understand the...
  4. KVgeo

    Vane Shear Test Results

    @ all above... While I can understand your desire to help educate young engineers, it has become clear to me that replying to questions such as the one above may not be the prudent course of action. It worries me that somebody performing slope stability analyses does not understand the...
  5. KVgeo

    Vane Shear Test Results

    @rgspringer 1st question) If you are asking this question you are not qualified to do a slope stability analysis. This shows a fundamental lack of understanding in basic geotechnical engineering. Read a text book or ask a senior engineer to explain to you the difference between undrained and...
  6. KVgeo

    GEOTECHNICAL INVESTIGATION PER IBC-2009

    Since there hasnt been any recent activity, I can only assume that the original poster got what he needed. However, I think this topic is a further example of the disconnect between structural and geotechnical engineering that exists in consulting practice these days. In general these days it...
  7. KVgeo

    Engineered Fill Settlement - near in-ground pump station

    @ATSE: Geotechnical engineering is not easy. There are no codes which provide definitive absolute parameters for soils. In most cases engineering judgement is required by an experienced professional geotechnical engineer. Given the above, when asking for geotechnical advice, you get what you...
  8. KVgeo

    moisture correction for marine sediments

    You have to remember that freezing has a capillary effect and that moisture can rise up from the groundwater table. In some cases, frozen samples of soil will have a significantly higher moisture content than samples taken at similar depths in the middle of summer. Hence most road damage...
  9. KVgeo

    Sudden Long-term Settlement of foundations

    @CEFDESIGN What part of Victoria are you in exactly? Please give us some idea of the subsurface conditions beneath the house. If you have engaged a geotech then you should have a borehole log with UCS classifications of the subsurface soils. Without knowing where the site is located, here are...
  10. KVgeo

    spt correlations to su

    What are you using the correlation for? Is it a critical project? Then I would suggest that this approach is not appropriate and that you should attempt to recover undisturbed samples and do triaxial/shear box testing. Or, Perform oedometer testing and calculate OCR values and use a standard...
  11. KVgeo

    What Liquefaction Screening Assessment Methods Are People Using?

    dgillette, Yes I mean the EERI book. For the most part the book is just a summary of previous papers on the subject. I do have several issues with it regarding sections on calculating CSR i.e. recommendations for using site specific dynamic response analyses for deep profiles with no...
  12. KVgeo

    What Liquefaction Screening Assessment Methods Are People Using?

    Just trying to get an idea of what the industry is using at the moment. Boulanger and Idriss (2008) Seed et al (2003) or something new...
  13. KVgeo

    How to intrepretate the penetrograph of soil penetration resistance

    The benefit of using the DCP is that the test is usually performed after about a metre and a half of fill placement. The fill is usually placed in accordance with a method specification which is determined at the start of the job by trial runs and nuke testing. The DCP is used for production...
  14. KVgeo

    How to intrepretate the penetrograph of soil penetration resistance

    dgillete, AS (Australian Standard) 3798 - Guidelines on Earthworks for Commercial and Residential Developments - Section 7.2, allows for indirect in situ testing methods to assess in place dry density. In direct methods include penetrometer testing as specified in AS 1289.6.3.2 and require...
  15. KVgeo

    How to intrepretate the penetrograph of soil penetration resistance

    gadderrao, I am not sure I have ever heard of a penetrograph. Is it like a Dynamic Cone Penetrometer (DCP) or a McIntosh Probe? In Perth, Western Australia, compaction testing for large sand fill projects is usually done with a DCP. Reference penetration values are usually established with...
See more

Part and Inventory Search

Back
Top