Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by kunal01

  1. kunal01

    flange leakage

    hi, for piping flange leakage calculations, how much flange allowable stress multiplier can be considered as per code? kunal
  2. kunal01

    why yield stress is used as allowable in B31.3 chapter IX?

    Thanks BigInch & Auzie5. Auzie5, you mean that Chapter IX method of calculation will be highly advantageous for the material having high yield strength. Am I correct? regards, kunal01
  3. kunal01

    why yield stress is used as allowable in B31.3 chapter IX?

    hi BigInch, could you explain me further? I am not getting the message. kunal 01
  4. kunal01

    why yield stress is used as allowable in B31.3 chapter IX?

    hi, you are correct. both are different codes. some specific reason will be there for considering only 2/3 of Yield strength. i am looking for that reason. kunal 01
  5. kunal01

    why yield stress is used as allowable in B31.3 chapter IX?

    hi, In B31.3, Appendix-A is providing allowable stress based on 1/3 of tensile stress or 2/3 of yield stress, whichever is lower. why Appendix-K for chapter IX piping is considering 2/3 yield stress is allowable stress? Any specific reason? Kunal01
See more

Part and Inventory Search

Back
Top Bottom