Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ksterling15
-
Calculate Diametric Tolerance
What do you mean "understand the requirement"?- ksterling15
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Calculate Diametric Tolerance
I have some tolerances that were calculated through a CETOL study in the X and Z directions. I need to convert these to diametric tolerances. I am not sure how to do this. Nut 1 tolerance is Z=81+/-1.05 & X=213.4+/-1.26 Nut 2 tolerance is Z=81+/-0.938 & X=103.4+/-1.26 Nut 3 tolerance is...- ksterling15
- Thread
- Replies: 4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
