I just installed abaqus v6.4 and is having difficulty getting abaqus to execute in the abaqus command window.
I typed in the "abaqus j=xx inter" at the command window prompt and it is displayed as:
E:\Temp\abaqus j=xx inter
and the following error message was observed in the command window...
I have looked at the .msg file again. ABAQUS was able to resolve the contact but unable to achieve equlibirium. In this case, how should I resolve this?
If I have to introduce damping to the contact, how should I go about doing it? BTW, thanks for the advice on the explicit bit, I will keep...
I am having problems getting ABAQUS Standard 6.2 to solve an indentation simulation. The description of my model are as follows:
-Axisymmetric modelling of soft tissue indentation (rigid indentor indenting a rectangular block)
-Rigid body for hemispherical ended indentor using a reference node...
