Recent content by krue0101

Hello, I am applying hall sensors and are looking for reputable Neo magnet material manufacturers (not distributors) to produce 200,000 pieces per year. Any help would very appreciated. Joe

Hi Hudson, I am just looking for an ergo hand similar to what UG Jack creates. Any help would be appreciated. Best Regards, Joe K.

Hello, Does anyone have a 3d human hand that they would be willing to share? Thanks in advance for your help. Joe

Hello, I am in need of a human hand model for NX and was wondering if anyone knows where I could find one or would be willing to share theirs with me. Best Regards, J

Hello, I am frequently asked to repair castings via welding or brazing and I do not know of a way to distinquish between a cast iron and cast steel casting. Does anyone have a way to tell if a casting is made of steel or iron? Thanks in advance for your help. krue0101

I am trying to convert some test specifications from ASD to PSD and make sure I am getting equivalent requirements. Some research I have done say ASD is the same as PSD. I don't know what to believe. Could anyone help me out on this issue? Your experience would be appreciated. Thanks Joe

Hello, I am searching for any general design tips on how to design a convoluted boot correctly. Does anyone have any ideas where to find this type of information? Suppliers? Application info? Any help would be very appreciated. Best Regards, joe

Hello, I was hoping someone might have training info avaialable for Nx NASTRAn. Any help would be appreciated as I am stumbling through the contact element nuances blindly. Thanks You. Joe

Hello, I have a zinc on zinc ball and socket joint that has a very low contact pressure in the joint but it stills wants to wear out. I am using Zamak 5 on Zamak 5. Does anyone have any ideas on how to solve this wear problem? I would like to remain with zinc die cast parts. Thanks, JJ

Hello, I have the need to fasten two dissimilar thermoset parts together. Does anyone have any ideas how to do this? Is there any type of welding that might work? Is there any type of adhesives that might work? Any help would be appreciated. thanks, Joe

Hello, I was wondering if anyone might know where I can find a design guide/ book/ articles on designing and qualifying fixtures for a shaker table. I know that designing the test fixtures is an important step in vibration testing and any help on this subject would be appreciated. Thanks, Joe

Thank you for sharing your expertise, it is much appreciated. Joe K.

Thank you for sharing your expertise, it is much appreciated. Joe K.

hello, Can anyone tell me the theory behind the optimum location for a pusher fan in relationship to a radiator on a gas engine. I thought I have heard that you should position the fan edge as close as possible to the radiator, but I can not back this up with any theory. Can anyone give me a...

Hello, I am trying to determine the optimum clearance between the fan and radiator on a gasoline engine. I am talking about a pusher fan that is pushing air through a liquid radiator on a home made tractor. It seems like I have found somewhere that the fan should be placed as close to the...