Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by krooney2
-
Parallel geometric dimension vs standard dimension and tolerance
Thanks a lot for the notes. I apologize for being elementary at this, I don't fully understand the appropriate way to dimension this. The blue component is silicone and the green component is aluminum. I am not worried about the overall size of the blue component, just that its top surface is...- krooney2
- Post #8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Parallel geometric dimension vs standard dimension and tolerance
3DDave, thanks a lot for the quick reply. Assuming that flexible edge is tilted, does the original dimension & tolerance mean the entire edge must be within the limits or just the average of the edge? I'm not sure how to interpret what is shown.- krooney2
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Parallel geometric dimension vs standard dimension and tolerance
Hi. I am dimensioning a flexible component relative to a fixed datum surface (A). I want the flexible component edge to be parallel to the datum within the +-0.5mm tolerance. Does the below dimension alone ensure the ENTIRE flexible edge is within the 0.5mm tolerance? Or do I need to add a...- krooney2
- Thread
- Replies: 8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
