Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Koror

  1. Koror

    GD&T help

    Thanks, This GD&T is new to me...I studied as a mechanical engineer but never had to use tolerencing in any of my designs. Machinist handbook sounds like a good idea...any suggestions? -K
  2. Koror

    GD&T help

    Thanks, Yes I am a novice in GD&T, hence the reason for signing up to this forum and asking for some advice. Maybe you could let me know what other input I would need to make a useful dimensioning determination? K
  3. Koror

    GD&T help

    Hello, I need to know how to use GD&T to dimension a shaft(R=5, L=14) assuming two cases: 1) it will be mating inside a cylinder(already dimensioned and tolerenced) 2) it will not be mating with anything Can anyone give me a general overview of what tolerencing I need for both cases? Thanks K
  4. Koror

    GD&T help

    Hello, I need to know how to use GD&T to dimension a shaft(R=5, L=14) assuming two cases: 1) it will be mating inside a cylinder(already dimensioned and tolerenced) 2) it will not be mating with anything Can anyone give me a general overview of what tolerencing I need for both cases? Thanks K
See more

Part and Inventory Search

Back
Top Bottom