Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by KonQueR

  1. KonQueR

    Laser Operator Skill Matrix

    Can any one tell me where I can find a Laser Operator skill matrix. Thanks
  2. KonQueR

    Copper slat.

    Hi guys, Thanks for all the reply, Henry was spot on about power being to much. jonnyboy23, the reason why i said unfortunately for the Bytrans is that the Finger for the Bytrans is made out of Ali, ands its very easy bent. Also to get a replacement for those finger cost an arm and a leg, it was...
  3. KonQueR

    Copper slat.

    Hi guys, I just replace new copper slate and having difficutly with flash back when nitro cutting,I am running a Bystronic Byspeed 4020 with Bytrans (unfortunately). Is there any solution to minimise this. Any suggestions is greatly appreciated. Thanks
  4. KonQueR

    Bystronic 4020 Dirt and SPOT @ back of Lens.

    Hey Henry, 24hrs of Cutting 10-20mm Mild Steel and a couple of thick S/S and NO SPOT or mark on lens. Thanks mate
  5. KonQueR

    Bystronic 4020 Dirt and SPOT @ back of Lens.

    Thanks for that advice Henry I will change the gas pressure standby to 2bar and run a few jobs and see how it goes. I'll keep you inform. Thanks mate.
  6. KonQueR

    Bystronic 4020 Dirt and SPOT @ back of Lens.

    Hi Henry, We are using ByVision with this Byspeed. The default Gas pressure standby on most of the parametre is about 1-1.2Bar
  7. KonQueR

    Bystronic 4020 Dirt and SPOT @ back of Lens.

    Hey guys. I getting black spot and little dirt on the back of my lens. I went through 5 lens in the last 5weeks and I have asked LMC ( Australia Bystronic Rep). But it seem this guys has no clue whats goin on. They ask me to check all the seals, change the distance piercing and put more gas...
  8. KonQueR

    Bystronic 6Kw Bystar "W-Axis warning error"

    Yes Bruno,it only happen when the head is lowering. I try changing the bearing but it only work for a short time. The other reason LMC gives me is that the W-axis card need replacing but that would take 3-4weeks. The machine still work fine, quality is very good. This W-axis warning error happen...
  9. KonQueR

    Bystronic 6Kw Bystar "W-Axis warning error"

    Hi all, I am currently using a Bystronic Bystar 6kw. I have a W-axis warning error that i cant seem to fix. I call LMC (Bystronic representative in Australia) But it seem like they dont know how to fix the problem aswell. Any one out there can help me out with this problem.? Thank-You
See more

Part and Inventory Search

Back
Top