I think that that just changes the views, but thanks anyway.
I also considered changing the sketch planes, but that is also a lot of work.
I ended up exporting the part to an .igs file with the proper coordinate system. Then I made my drawings and the CM software is ok with it.
This was the...
I was making a part in the part editor.
I goofed up and made the right side the front, the top the left, etc... as far as X,Y,Z is concerned.
Is there a way that I can change the coordiante system without starting from scratch.
I seem to be able to add a coordiante system, the I can't make...
Wow, I have been try to figure out how to do exactly this for several days now. I keep running into the tagent problem.
Can anybody elaborate on this solution? It isn't quite clear to me as to how this cut was created.
Wow, I have been try to figure out how to do exactly this for several days not. I keep running into the tagent problem.
Can anybody elaborate on this solution? It isn't quite clear to me as to how this cut was created.
