Recent content by kniff

Hello, i know this is a bit of a long shot but i will ask anyway. i am currently trying to match FEA results from ANSYS with FEA results from ABAQUS in CATIA V5. I need to understand how to replicate the restraints of ANSYS with ABAQUS. Specifically, i need to replicate the ANSYS constraint...

Hello, i know this is a bit of a long shot but i will ask anyway. i am currently trying to match FEA results from ANSYS with FEA results from ABAQUS in CATIA V5. I need to understand how to replicate the restraints of ANSYS with ABAQUS. Specifically, i need to replicate the ANSYS constraint...

Hello, i know this is a bit of a long shot but i will ask anyway. i am currently trying to match FEA results from ANSYS with FEA results from ABAQUS in CATIA V5. I need to understand how to replicate the restraints of ANSYS with ABAQUS. Specifically, i need to replicate the ANSYS constraint...

cheers that is exactly what i needed. its a bit messy but it works cheers again

sorry i did not explain very clearly. I will try again. I have an assembly and i want to view the results of a single component in that assembly. Essentially, i have two connected parts and i want to hide part1 so that i can view all surfaces of part2 and then visa-versa. So although i have...

Sorry should make it clear that i am using: Catia V5, R18, SP5 with the GAS license

is there something i need to do in pre-processing to allow me to do this when results are shown?

I would find it extremely useful if someone could tell me how i would go about viewing the individual visual results (i.e. principal stress) of a single component of an assembly when the analysis has been carried out on an assembly using GAS. I have two individual meshes and connection meshes...