Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by KM660

  1. KM660

    Pond outlet structure modeling question

    Not sure you will receive this Peter but hope you do as you responded to my initial post. I now have to modify this same outlet structure by putting a v-notch weir plate on it. I now am unsure as how to model this v-notch at an angle like the existing opening. The only outlet category I see...
  2. KM660

    Pond outlet structure modeling question

    Thank you Peter. I had the same thought as you (and yes, the structure has two outlet culverts inside) but I couldn't see where I could model the inlet orifice at an angle. Finally figured out that I had an older version of HydroCAD that did not allow for this. The newest version does and the...
  3. KM660

    Pond outlet structure modeling question

    I was wondering if anyone could help me on how to properly model the outlet structure in this picture in HydroCAD? Thank you.https://res.cloudinary.com/engineering-com/image/upload/v1725037177/tips/OUTLET_STRUCTURE_k4x7dk.pdf
See more

Part and Inventory Search

Back
Top