Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by kkjhs
-
material properties ASTM A401
Thank you very much. In my case it is a torsion bar (.148" x .148" ).- kkjhs
- Post #4
- Forum: Metal and Metallurgy engineering
-
material properties ASTM A401
HI, I am searching for material properties for ASTM A401 especially modulus of torsion and ultimate tensile strength. I have looked up matweb.com but have not found it. Thank you.- kkjhs
- Thread
- Replies: 4
- Forum: Metal and Metallurgy engineering
-
literature standards and tolerances
I am searching for books which contain 'How do I draw right concerning metric and english standards' and 'Handbook for tolerances (shape, position, fittings...) and other often used data for design and calculation'. Do you recommend the following books: TECHNICAL DRAWING by Giesecke, Mitchell...- kkjhs
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
-
recommended literauture
I am searching for books which contain 'How do I draw right concerning metric and english standards' and 'Handbook for tolerances and other often used data for design and calculation'. Do you recommend the following books: TECHNICAL DRAWING by Giesecke, Mitchell, Spencer, Hill... ENGINEERING...- kkjhs
- Thread
- Replies: 2
- Forum: ANSI (standards) Code Issues
