Thanks Dingy. This is an old drawing done by someone no longer here. I'm engineering so there's no one else to ask here, lol. Hence the reach out to the internet. I'm pretty sure you can't have a MMC modifier as a basic dimension has no max or min. I think its just an error =P
I am looking over some drawings and I saw some basic dimensions, each with a positional tolerance that has a MMC modifier (see attached). Is this 'legal'? I've searched eng-tips and and the ASME Y14.5M-1994 (specifically section 2.8 APPLICABILITY OF RFS, MMC, AND LMC) and can't find an answer...
Phim - To get better control of the surface shapes in a Boundary Blend, use the "CORRECT_TANGENCY" sketch as second direction curves. I took your TANGENTBLEND_CORRECT_TANGENCT.prt and patterned the CORRECT_TANGENT sketch again 4x around the axis (REF 001.bmp). Now the sketches are set-up and...
A VSS will do what you want. I have wf4 but I've attached a screen shot of how to set it up. I used your existing sketch 2 and mofifed it to only use the arc and straight portion. DTM1 is 15 units from the top datum, the same distance as your extrusion.
A condition of a VSS (variable...
The most surefire way is to format and then install XP. Be sure to back up all your critical data to a CD or other hard drive (thumb drives rock for this).
Or you could create another partition and install XP on the new partition. If you do that then you could keep Vista (if you want to) and...
you are forgetting step 1: generate image of system
Like a backup? Oh that's done automatically once every two days with Acronis. I've lost too much before to not have a backup system. Especially running a RAID 0 + RAID 5 array now it's mandatory ::-)
No need for a weekend project. It...
I previously knew about it with the earlier GeForce and ATI cards and was hoping that it would be possible when I bought my video card and current computer setup (August '07). At the time it wasn't so I began looking around again recently. I came across a SWUG Forum page where the person had...
