Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by kennedyg

  1. kennedyg

    PLASTIC COMPRESSION

    Plastisol will give you a rubbery part. If you want something harder, you could always mold it from epoxy. Either way, be sure to use mold release.
  2. kennedyg

    Has anyone heard of "Impact" welding plastic?

    Several months ago I read an article about a new technique for joining plastic parts. It involved sliding a boss into a hole at a high rate of speed. The design was to have an interference fit. A small displacement at high velocity is intended to generate sufficient heat to weld the parts...
See more

Part and Inventory Search

Back
Top