Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by keithtop

  1. keithtop

    dimple jackets

    Hi Everybody, Does anyone have the design calculations for dimple jackets on stainless steel vessels? I dont think its adequately covered in the British Standards 5500 where it says use as a flat plate & in doing so suggests a ludicrous pitching of 2.875" which is far too small a centre...
  2. keithtop

    Does anyone have the formulae for working out the DEFLECTION of a BUILT IN BEAM with TWO POINT LOADS

    Does anyone have the formulae for working out the DEFLECTION of a BUILT IN BEAM with TWO POINT LOADS. I used to have this info., when I was a student 50 years ago, but obviously cant remember it now. All the info. on the web only gives it with one load in the centre. I would be very grateful for...
See more

Part and Inventory Search

Back
Top