Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by KeithJC
-
Weld Symbol Simplification
Thanks Al, that clears it up quite a bit; As I understand your answer unless I have specific reason for needing a weak weld (save time/cost heat) or a CJP weld it would be common practices to just use the symbol with no size and allow D1.1 to dictate the size of weld from the min and max tables...- KeithJC
- Post #3
- Forum: Welding, Bonding & Fastener engineering
-
Weld Symbol Simplification
Hi All, Regarding simplification of weld symbols on drawings I was wondering about a survey of industry standards and best practices for a couple of cases: 1. In the case of an all around weld that spans weld types but with no special preparation is it normal/acceptable to group the callout...- KeithJC
- Thread
- Replies: 2
- Forum: Welding, Bonding & Fastener engineering
