Thank you all for your reply,
rb1957,
There is a guide pin between both parts in order to avoid rotation. I did not add it in my drawing because it is only a draft. I will use helicoil on the thread. There is not any thermal effects (room temperature, about 70°F).
I do not know if it is...
Desertfox,
Please see the attachment. I changed it a litle bit. I will use only one bolt.
Please, let me know if it is enough.https://files.engineering.com/getfile.aspx?folder=19bb613a-0220-435f-a8fa-27101f924baa&file=Bolt_size.png
Yes, however I am Electronic Engineer.
I would like to attach a stainless steel part to the aluminum part by bolts. The length of the thread on the aluminum part must be 15mm. I know I must calculate the shear on the aluminum thread to choose the correct screw, but I don't know how to do it...
Hi everyone,
I have a question about sizing a bolted joint. How to calculate the size of the screw? Knowing that the bolt material is 316 stainless steel and the thread material where the bolt will be bolted is 6061 aluminum. This screw will be pulled at 2000N.
Thanks!
