hai netjack,
Thank you foryour reply,I am using Ansys.I am interseted in stresses at Bolts,Being they are in rotation , i am in confusion to give the DOF,
Thank you again
Flanges aer connected to echother ,rotating at some angular velocity.My doubt is
How to simulate the bolted joint in the flanges which are conn to each other,
1.whether we have to fix ii in any dof/shall we take it as free one with out any dof,
2.if it is free , how to constrain the flanges...
i need the details of Constraints to fix the shaft,which is connected to roller bearing at their ends.
Shall we take it as radial,axiallly locked ,allowing tangential dof only is it corect,
i need the clarification any one could help on this issue
Thanks a lot for your Interest towards me.
My Assumption is I want ot include the inertial effects , to know the stress pattern at varying speeds,
But the Problem is As mentioned in above,
Can you give me tips.
Kathir
The analysis of circular disc, is the project .On that i have included both Speed AS angular velocity in rad/s.this is carreid out through Ansys.On varying the speed , the stress values are not changing. i assigned everything such as density in kg/m3.Eventhough the answer is not Converging...
Dear Sir,
I am doing the project,”Failure Analysis of flywheel”.While calculating the fatigue values, I have
assigned all the datas required. But the error comes as Nloc error, but I have located
only one node for single event. Even though, answer is not coming. Nvalues are missing...
