Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by KaptainK
-
Assist gas regulator
Anyone know how to do a zero set calibration or check on the O2 reg for R4725? Our used 2004 FO3015 machine was acting like this (but spiking high then coming down to normal) when I set it up. I had an Amada tech here to check a couple things and he did a quick procedure to calibrate zero on the...- KaptainK
- Post #4
- Forum: Laser engineering
-
1 inch thick with Amada FO3014 4000 watt
Use a 3.8 or 4.0 DBL wacs nozzle only BTW.- KaptainK
- Post #6
- Forum: Laser engineering
-
1 inch thick with Amada FO3014 4000 watt
As Laserninja says, it can be done. Good material, good consumables, good optic condition and alignment inner and outer oscillator, Good condition of cooling circuit, mint focus lens needed. Feed on E4 22-24 IPM, 4000watts,Freq. 850-950, Duty 90-95, O2 .04-.05, Focus .160-.220 - E2 for 1'' holes...- KaptainK
- Post #5
- Forum: Laser engineering
