Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by KANSASENG22
-
Help on disposition!
I do have enough room to plug and relocate to dwg location. I will take a fatigue hit so it is now in Stress for validation. Thanks to everyone.- KANSASENG22
- Post #4
- Forum: Spacecraft engineering
-
Help on disposition!
I have a rivet hole for a standoff (wiring)that has been mis=located and now a .128 diameter hole is in the radius of a machined beam, The beam is on a pressure bulkhead, the flange common to the radius would be mostly in tension. The beam flange is .300 thick, radius is .38, beam material is...- KANSASENG22
- Thread
- Replies: 7
- Forum: Spacecraft engineering
