I have to recover GLAUBERS salt from a textile waste containg 3.5 percentage Na2So4. The waste water generation rate is 1000liters per hour. I have to design the waste treatment system for zero effluent discharge. Steam is avialable at 8 barg pressure and cooling water supply is available at 20...
the inductive reactance X of any transmission line can be witten as below.
X = 0.004657*f*log(Ds/GMR) ohm/mile/conductor
Where Ds - equvallent spacing in feet
GMR - Geometric mean radius in feet
f - frequency in Hz
Now the unit mile is to be changed as km (ie reactance in ohm...
In a typical EHT transmission line, having similar conductor size (say Kundah conductor for 230KV), from the actual measured value for different kms, the calculated resistance and reactance per km are not similar. Why? The method of measurement of the line is not known.
thank you for your response. In a chemical plant to meet the auxillary consumption of the plant, a captive generator set has been suggested having a capacity of 10MW. In this case what is the base load operation of the gen. set
