Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by kalapani

  1. kalapani

    nozzle loads

    It depends on where the nozzle loads where calculated. If the loads were calculated at the flange then you build a model with the nozzle and apply the load at the flange.
  2. kalapani

    Automatic priming method Gould SSH pump

    I have Gould end suction SSH pump (4SH2K52B0) pumping water out of cooling tower via 2" piping maybe 2 ft long. On loss of CW make-up and subsequent shutdown air gets introduced into system. Operator start the pump but forgets to bleed air from suction at start-up. This later result is a...
  3. kalapani

    H2 gas compressor

    Has anyone used a Blackemer HD liquid cooled product to compress pure hydrogen say from 100psig to 300psig? Was the experience a success?
See more

Part and Inventory Search

Back
Top Bottom